User's Manual
Table Of Contents
GALAXY® II Gateway Receiver
Figure 24: RJ45 plug assembly with Code A orientation
4. Insert the insulator assembly into the metallic housing using the Code A orientation as shown in Figure 24. You will
hear a ”click“ to conrm a complete connection.
OTE:N Code A orientation must be used or the plug will not fit into the receptacle. Assembled RJ45 plugs cannot be
disassembled without a special tool (67163-001) and must be replaced.
5. Screw the cable gland into the metallic housing and tighten the cable gland nut to 30…45 inch-pounds
using wrenches.
6. Tighten the dome nut to 20 inch-pounds using a wrench. The dome nut seal must be in rm contact with outdoor
rated Cat.5e Ethernet cable.
7. Remove the bayonet lock cap from the RJ45 receptacle on the gateway enclosure by turning the cap 1/4 turn,
counter-clockwise.
Figure 25: RJ45 receptacle bayonet lock cap (LAN with power shown.)
8. Connect the RJ45 plug assembly to the RJ45 receptacle and secure by turning the metal housing 1/4 turn, clockwise.
OTE:N Do not use a serial-to-LAN adapter on the GALAXY II gateway receiver
For additional information, refer to http://www.rjfield.com/ethernet_connectors_rjf_en.htm.
RJ45 Receptacle Bayonet
Lock Cap
Page 22 February 2014