Installation Guide

First InterComm

™

System Installation Guide

Page 14 A29799

November 2007

6.2 VCA100 Update Procedure

1. Appendix B contains instructions for operating the Serial IP and the VCA

MANAGEMENT PROGRAM.

3. Follow the steps as listed in Table 8. Correct any problems encountered before

proceeding to the next step.

Table 8. VCA100 Update Procedure

Required Items:

a. VCA100 Installed in vehicle

b. User Parameters (Table 7 of this document).

c. Installer’s WiFi Laptop configured using BAE Systems’ Installation CD

Step Procedure

Expected

Result

Verified

1 Turn on VCA100. Wait one minute for boot up to complete. Booted

2 Turn on the laptop and connect to First_InterComm_Network Connected

Execute VCA

MANAGEMENT PROGRAM (see Appendix B in this

document) and input specific User Parameters.

Updated

Close VCA

MANAGEMENT PROGRAM and launch Serial IP program

(see Appendix B in this document)

Running

Program VCA100 RF module with specific User LMR frequencies

and PL Codes.

Programmed