User's Manual

4
6,8
9
10,11
12
13
14
Photo 13
4. Locate the blue wire from the gray multi-conductor cable and connect it to
the black wire coming from the fuse block.
5. Locate the black male lead from the gray multi-conductor cable and
connect it to the black/yellow lead of the stock wiring harness that formerly
connected to the stock taillight. Note that the stock red wire will not be used in
this installation.
6. Plug the red male terminal from the taillight into one of the red female
connectors from the wiring harness.
7. Run the red and blue brake light switch wires up to the area behind the airbox.
8. Plug the red wire from the brake switch into the open slot of the red double
female connector of the gray multi-conductor harness. Do this by doubling
the red wire of the brake switch back on itself for a clean wire run.
9. Plug the blue lead from the taillight into the blue lead from the brake light
switch.
10. Plug the black lead from the taillight into one side of the black double
female connector.
11. Plug one of the leads from the left turn signal into the other side of the black
double female connector.
12