User's Manual

5
9. Rear Turn Signal Installation:
Turn signal mounting requires that
you drill a 15/32 inch hole in either
side of the rear fender near where it
meets the side panels. You can
achieve a clean, durable installation
using this mounting location..
Mount the rear turn signals by
drilling a 3/8" hole in the rear
fender in the location shown in
Photo 3, three eighths of an inch
back from the front edge. If you
desire the turn signals to be
completely level, use a 3/8 inch
diameter bolt and nut to sandwich
two fender washers on the inside and
outside of the fender. Carefully heat
the inside of the fender with a heat
gun until you can pull the bolt down
to horizontal. Reinstall turn signals.
3/8”
7/16”
Photo 3
Photo 4 - Left Side
Turn Si
gnal Mounting
Run the left turn signal wires along
with the taillight wiring forward
along the left frame rail to the area
just behind the airbox and above the
fender. Run the right turn signal
wires forward along the right frame
rail, and up to the same location
behind the airbox.