User's Manual

14. Turn Signal Switch Installation:
Install the turn signal switch on the
left handlebar next to the grip as
shown in Photo 8. The switch has a
single screw that pinches it together
on one side. Two tabs secure the
switch halves on the other side.
Remove the screw to separate the
halves so that it can be installed on the
handlebar. When installing the switch
to the handle bar, make sure the tabs
are seated in their locating holes and
then tighten the pinch screw. DO
NOT OVER TIGHTEN THIS
SCREW, as too much force can strip
the body of the switch. The clutch
perch will have to be moved to the right to make room for the switch. Run the wires
along the backside of the handlebar and down over the front of the triple clamps.
Photo 8
8
15. Hi Beam Indicator and Bracket:
Install the high beam indicator bracket
under the left hand handlebar pinch
clamp bolt as shown it Photo 9.
16. Stator Connections: Reinstall your stator assembly at this point if you haven’t done
so already. Run the stator wire as before to the connections near the front right corner of
the airbox. Plug the black wire from the stator into the black wire from the CDI unit
(Refer to Photo 1 for CDI Unit location). Plug the red/white wire from the stator back
into its red/white mate from the CDI. Leave the black/yellow and blue wires from
the CDI plugged into the stock harness.
Photo 9