User's Manual

Connect the yellow wire and the new white wire from your rewound stator to the two

yellow leads with male connectors coming from the Baja Designs rectifier/ regulator.

They should connect just below the seat rail at the right hand side of the airbox as shown

in Photo 10 and the color photo.

Photo 10

Connect yellow and

white stator wires

to yellow regulator

wires here

Photo 11

Cable

Routing

17. Wiring Harness Installation: Locate the long multi-conductor cable with the nylon

multi-pin connector at one end. Gently plug this connector together with the one in the

front wiring harness. Do not force. If you have trouble plugging the two together,

realign the male pins with a small screwdriver to get a good match. Note that dielectric

grease has been applied to the female terminals to help prevent corrosion. This grease

can be purchased at any automotive parts store. With the handlebars fully turned to the

right to make sure there is enough slack in the cable, run the wire down along the stock

wire guides, past the ignition coil , along the front cross-member to the rectangular