i i 1. Remove cardboard carton. 2. Remove all parts neededfor assembly and set aside. Centerstand 3. Place unit on centerstand for easy assembly.
Mat for inside compartment Handlebar levercovers and hardware Cargo compartment/ and hardware Front nose piece Pedals, crank and plasticcover Front wheel fender 2
Rear axle and chain covers and hardware Mirrors ! Tool Kit Manufacturer Certificate of Origin Owners Manual Batterycharger
Nut 4. Insert left and right mirror into hole on handlebar and turn clockwise,secure by tightening nut. Phillips head bolts Bracket Washers and nuts 5. Place cargo compartmenton rear rack of unit. Attach using two phillipshead bolts. 6. Securecargo compartmentwith bracket, washersand nuts provided in hardware bag.
7. Fillbothfront andreartireswithair.Tire pressureshouldbese to 36psi(250kpa). 8. Attach front wheel fender to front forks with four phillipshead screws,two for each side. 9. Align front nose piece under front panel and snap into place.Securewith two phillipshead screws.
10. Attach each cover to frame using two washers and two phillipshead screws. Crank sha_ Crank 11. Removeand save nut from pedal crank shaft. 12.Attach left and right cranks to crankshaft. NOTE:Each crank will be labeled L or R for left or right. Secure crankto shaft with nut previouslyremoved.
Pedal Nut Crank Cap 13. Attach left and right pedals to cranks. NOTE: Each pedal will be labeled L or R for left or right. Securepedal to crank by tightening nut on pedal. 14. Place cap cover over nut on crank. Tab Mud flap phillip head screws 15. Place opening of mud flap over tab of mud flap attachment.Securefrom behindwith two phillips headscrews.
16. Attach each handlebar lever cover using 2 phillips head screws provided. Outlet Charger Master switch located under seat 17. Charge battery before use. Turn master switch "ON". Plug charger into outlet belowseat cushion. Refer to owners manualfor chargingtimes.
