Owner`s manual

NON-POLAR

CAPACITOR

INDUCTOR

(COIL)

L E G E N D

Left

Mid / Tweeter

4 Ohm

(2 Ohm Minimum)

Mono Woofer

8 Ohm

(4 Ohm Minimum)

Right

Mid / Tweeter

4 Ohm

(2 Ohm Minimum)

¹F100

CAUTION! In Tri- mode operation, the amplifier must see a 2 Ohm load or higher for the

stereo satellites and no lower than 4 Ohms for the subwoofer(s).

Any lower than the above mentioned impedance will cause internal damage

to the amplifier.

SPEAKER CONNECTIONS (TRI-MODE)

All 2 channel amplifiers are capable of running both in Mono & Stereo mode. This feature

gives the amplifier the ability to run stereo satellites (midbass & tweeter) simultaneously

with a mono subwoofer.

These connections are more complicated because they require the use of passive crossover

networks (Not provided) to divide the frequencies to the speakers. We have included a sample

diagram for 4 Ohm connections. If you wish to use multiple speakers to achieve a lower

impedance and higher power, it is strongly recommended that you seek professional advice

from your Profile retailer before attempting to make these connections.

Please Note: In the Tri-mode configuration, the amplifier's built-in crossover must be set to

"FULL"(OFF) position.

4mH