Owner`s manual

IF YOU APPLY POWER TO SYSTEM AND DO NOTHING ELSE:

1. The primary filter cycle will occur in 24 hours and run for 120 min.

This will repeat every 24 hours.

2. The spa will heat up to and maintain 100º F.

(The freeze protection mode is available if required.)

TO SET OR CHANGE THE FILTER CYCLE START TIMES:

Refer to PROGRAMMING FILTER CYCLES in operating manual.

IF THE FILTER CYCLES ARE NOT RUNNING AT THE BEST TIMES FOR YOUR SLEEPING

SCHEDULE, YOU MUST PROGRAM THE SYSTEM AT A PARTICULAR TIME OF DAY TO

ADJUST THE INTERNAL SYSTEM TIME PATTERN.

Desired Filter Cycles Programming Time Filtering Time

1 Cycle per 24 Hour Period 8:00 PM 8:00 PM

2 Cycles per 24 Hour Period 8:00 PM 8:00 PM & 8:00 AM

3 Cycles per 24 hour Period 2:00 PM 10:00 PM, 6:00 AM

& 2:00 PM

Note: The easiest way to change the internal system time pattern is to simply TURN OFF ALL

POWER to the spa for (10) ten seconds and then promptly start your programming procedure.

QUICK PROGRAMMING NOTES

SPORTUB 1057-58 WIRING DIAGRAM

All Universal systems leave configured 120-Volt input power.

240-Volt electrical service required:

Line 1, Line 2, Neutral and Ground. 8AWG. Minimum

IMPORTANT: Always refer to the product

data label (located on top of Control Box) for

specific electrical information.

FACTORY PRE-SET FILTRATION MODES

Baja Spas Self Cleaning Spa Filtration Program has been designed to efficiently circulate 24 hours per day. The

circulation pump system will only turn off when the spa temperature exceeds 4 (four) degrees above the actual

temperature set point.

Baja Spas also added other factory filtration modes and conveniences:

Purge Mode: Everyday at approximately 12:00 Noon, the booster pump will operate for a few minutes to stir up

the spa water through the entire system.

Smart Summer Mode: In high heat climate areas, Baja Spas circulation filtration system will automatically

perform 2 special filter cycles that run at 10:00AM and 5:00PM respectively for 2 hours each to provide filtration

and ozonation.

Economy (EC) - Filtration (FL) Cycles: DO NOT CHANGE THESE FACTORY PRESET MODES!

Should you accidentally go into the programming mode after setting the clock and the spa topside controller reads

F1, 2, 3 (Filtration) or E1,2,3 (Economy) Do Not Change These Factory Preset Modes.

Simply step away from the spa for 2 minutes and the controls will automatically reset themselves. Changing these

modes will alter the factory preset settings.