Other Content

Insert the large flat bolt with the supplied rubber
washer through the front panel and silver slotted
bracket underneath. Repeat on other side.
BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 844-779-8986 • Fax: [phone] • bakindustries.com
Part# 318A0030 Rev. 5-3-16
5
Slide in
mounting
plates from
the end.
6
Trim
away
excess
flush
with
rail.
7
Mount the slotted cover
mounting plate in the
front as far forward as
possible. The top edge
of the plate aligns with
the rubber seal. Then
reinstall tiedown.
8
11
Set the cover in the folded position on the BakFlip
rails towards the front of cab.
10
The small panel
faces forward,
toward the cab and
folds down over the
silver brackets. The
front panel must
sit just inside the
bulkhead rail with
the seal resting on
top of the rail. Fold
the panel down and
align it so it is set-
ting squarely on the
rails and align the
mounting holes with
the silver slotted
brackets on the rails.
9
Before mounting the cover on truck, using a screwdriver
install the two buckle ends into pre-drilled holes on the front
header with the provided machine screws and threaded posts.
DO NOT use a screw gun, securely tighten by hand only.
IMPORTANT