Other Content

BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 844-779-8986 • Fax: [phone] • bakindustries.com
Part# 318A0030 Rev. 5-3-16
13
14
Mount cover with elevator bolt, rubber washer, flat washer,
lock washer and star knob in order. Center cover in the bed
opening and tighten.
Install prop rod
swivel mount
aprox 17 in. from
bulkhead so rod
swivels into the
slide lock with
some clearance.
The U shape
faces up.
15
16
17
Make sure
the latch
brackets are
in position
where they
will clear the
other hard-
ware like the
slide lock on
the cover.
18
Attached the prop rod retaining clip to the Ram Box rail
where it will meet the prop rod when rotated down.
Attach drain caps and drain hoses at each end. The
larger drain cap goes towards the cab and the smaller
caps installs towards the tailgate.
19
Install remaining
brackets where each
latch meets the rail.
The latch plate should
not touch the bottom
of the cover and should
latch when closed.
Cab bumpers attach on the
very top edge of the panel
facing the cab. The two
outer cab bumpers should
be 3 inches in from the
panel edge to prevent rail
interference when closed.
If your truck has a slider
window, the center
bumper should be cut
in two pieces and go
on each side of the
slider to prevent
direct contact.
The large flat bolt goes down through the front panel
on each side. Underneath the cover, the order of
washers is as follows: rubber washer first, then large
flat stainless washer, then the lock washer, and finally
the 5 star finger knob as shown to the left.
12