Other Content

BAK Industries • 720 Jessie Street, San Fernando, CA 91340 • 844-779-8986 • Fax: [phone] • bakindustries.com
Part# 318A0030 Rev. 5-3-16
STORAGE
POSITION
FOR CLIP
IMPORTANT
BAKFlip safe operation and use
IMPORTANT NOTICE
While driving, cover must be completely at and secure with all latches
in the closed position OR completely folded up (all panels) and secured at
the cab. DO NOT DRIVE with cover partially opened.
Tonneau Cover Positions While Operating Vehicle
Prior to vehicle operation, tonneau cover MUST be properly secured.
CLOSED POSITION
All panels must be closed and FULLY LATCHED to tonneau side rail.
All panels must be flat and latches engaged
FOLDED UP POSITION
To drive with your cover in the folded up position, simply make use of the
tie down straps and buckles provided with your cover. Ensure BOTH buckle
clips are fully inserted into the buckle ends located on the front header panel
of the cover and adjust the straps to ensure the cover is secure during
vehicle operation. The clips should be secured in the storage position,
as shown in Figure 1, when not in use.
FLIPPED UP POSITION
A) Fold the cover open and lift it until its vertical or
past 90 degrees towards your truck cab. Then release
the prop rod that is attached to your rail. Fold the
prop rod over and position it firmly against the
vertical plate on the underside of your cover.
Then slide the prop rod locks downwards
and tighten the knobs to lock into position.
Do this on both sides of the cover.
B) Your cover should be firmly in
position with little to no movement
once the prop rods are locked.
FOLDED UP POSITION
FLIPPED UP: B
FLIPPED UP: A
FIGURE 1