Fry Warmer MODELS FW-12, FW-15, FW-12T, FW-15T, FW-15DTO Service Manual Serial Numbers 120182 and Higher
Warranty Information LIMITED ONE YEAR WARRANTY BKI (The "Company") warrants to the original purchaser that at time of shipment from the Company factory, this equipment will be free from defect in materials and workmanship. Written notice of a claim under this warranty must be received by the Company within ONE YEAR from the date of installation, but no longer than ONE YEAR AND THREE MONTHS from date of shipment from the factory.
Fry Warmer Table of Contents Table of Contents Table of Contents .................................................................................................................................................... 1 Introduction.............................................................................................................................................................. 2 Safety Precautions ......................................................................................................
Fry Warmer Introduction Introduction Congratulations! You have chosen a Fry Warmer that will give you many years of fine service from the original manufacturer, BKI. The BKI name and trademark on this unit assures you of the finest in design and engineering — that it has been built with care and dedication — using the best materials available.
Fry Warmer Introduction Keep this manual with the Equipment This manual is an important part of your equipment. Always keep it near for easy access. If you need to replace this manual, contact: BKI Technical Services Department P.O. Box 80400 Simpsonville, S.C. 29680-0400 Or call toll free: 1-800-927-6887 Outside the U.S., call 864-963-3471 Protect Children Keep children away from this equipment. Children may not understand that this equipment is dangerous for them and others.
Fry Warmer Introduction Safety Labels 4
Fry Warmer Installation Installation Serious injury, equipment damage or death could result if attempting to install this unit yourself. Ensure that an authorized BKI service agent install the oven. Instructions For Shipping Damage You are responsible for filing all freight claims with the delivering truck line. Inspect all cartons and crates for damage when they arrive.
Fry Warmer Installation 8. Connect wires of power cord to power entry terminal block according to the wiring diagram attached to the unit or provided in the Service Manual. 9. Position main unit on the adapter and secure using #8 sheet metal screws. 10. Fit pan insert to main unit by lifting the open side of pan insert over the two tabs on main unit and lower the pan insert into the opening in the adapter. Countertop Cutout (FW-12 & FW-12T) 1.
Fry Warmer Installation Countertop Cutout 1. Obtain a suitable countertop location for the unit that will provide a clearance of 4” from the side louvers. 2. Cut a 16” x 18” hole in the countertop to fit the pan insert. 3. Using a 1/8” drill bit, drill holes in the countertop used to secure the main unit to the countertop. 4. Using a 2” hole saw, drill a hole in the countertop (under where the main unit will be secured) for the power cord to pass through. 5.
Fry Warmer Installation 4. Secure WB31216000 to countertop with # 8 sheet metal screws. 5. Seal WB31216000 to the countertop to conform to NSF Standard 4, Item 4.28. (Dow Corning RTV #732 Multi purpose Sealant.) 6. Feed power cord (supplied), up through holes in WB31216000. 7. Connect wires of power cord to power entry terminal block according to the wiring diagram attached to the unit or provided in the Service Manual. 8. Position main unit on WB31216000. 9.
Fry Warmer Installation 8. Position main unit on WB31211900. 9. Fit pan insert to main unit by lifting the open side of pan insert over the two tabs on main unit and lower the pan insert into the opening in the countertop. FW-15T/FW-15DTO (Bottom Breather) Countertop Collar Weldment With Liner Pan (WB31217700) 1. Obtain a suitable countertop location for the unit. 2. Cut holes in the countertop for the countertop collar weldment with liner pan (WB31217700) according to illustration below: 3.
Fry Warmer Maintenance Maintenance Failure to comply with the maintenance below could result in a serious accident. Electrocution, equipment failure or property damage could result if an unlicensed electrician performs electrical repair. Ensure that a licensed electrician perform electrical repair. Scheduled Maintenance Cleaning This unit should be cleaned at the end of each working day. Use the following procedure: Failure to remove power from this unit may cause severe electrical shock.
Fry Warmer Maintenance Troubleshooting Refer to the table below for troubleshooting information. Problem Cause Possible Solution Warmer chute is not holding heat Ceramic heating element failure Contact an authorized BKI service agent for corrective action. Noisy fan Fan blade is dirty or fan bearings are failing Contact an authorized BKI service agent for corrective action. FW-15/FW-15T/FW-15DTO (Bottom Breather) Warmer chute is not heating and perforated pan is not heating No power to unit.
Fry Warmer Replacement Parts Replacement Parts Use the information in this section to identify replacement parts. To order replacement parts, call your local BKI sales and service representative. Before calling, please note the serial number on the rating tag affixed to the unit.
Fry Warmer PART # B0066 C0119 C0080 CS0024 FB31204803 WB31219900 LH0021 M0093 P0129 P0121 S0356 Replacement Parts QTY 1 1 2 1 1 1 1 1 1 1 1 DESCRIPTION BULB, 40A15 130V TEFLON COATED CALROD, 120V 1000W 140C C/U SWITCH CALROD, 120V 400W CERAMIC CORD SET, 12/3 SJTO 8' 30"LEAD DIVIDER PAN FW CUF GREASE DEFL.RET.BRKT.
Fry Warmer Replacement Parts FW-12/FW-15 PASS THRU (Side Breather) 14
Fry Warmer Replacement Parts PART # QTY DESCRIPTION B0555* 1 BULB, 150W 240V HALOGEN COATED (220V England) B0066 1 BULB, 40A15 130V TEFLON COATED C0119 1 CALROD, 120V 1000W 140C C/U SWITCH C0080 2 CALROD, 120V 400W CERAMIC C0127* 1 CALROD, 220V 1000W 140C C/U SWITCH (220V England) C0057* 2 CERAMIC HTR 400W FULL SIZE 220/240V (220V England) CS0024 1 CORD SET, 12/3 SJTO 8' 30"LEAD FB31201503 1 DIVIDER PAN, FW15 WB31219900 1 GREASE DEFL.RET.BRKT.
Fry Warmer Replacement Parts FW-15 CUF (Bottom Breather) 16
Fry Warmer PART # B0066 C0119 C0080 CS0024 FB31204803 WB31219900 LH0021 M0093 P0121 Replacement Parts QTY 1 1 2 1 1 1 1 1 1 DESCRIPTION BULB, 40A15 130V TEFLON COATED CALROD, 120V 1000W 140C C/U SWITCH CALROD, 120V 400W CERAMIC CORD SET, 12/3 SJTO 8' 30"LEAD DIVIDER PAN FW CUF GREASE DEFL.RET.BRKT.
Fry Warmer Replacement Parts FW-15 PASS THRU (Bottom Breather) 18
Fry Warmer PART # B0066 C0119 C0080 CS0024 FB31201503 WB31219900 LH0021 M0093 P0121 Replacement Parts QTY 1 1 2 1 1 1 1 1 1 DESCRIPTION BULB, 40A15 130V TEFLON COATED CALROD, 120V 1000W 140C C/U SWITCH CALROD, 120V 400W CERAMIC CORD SET, 12/3 SJTO 8' 30"LEAD DIVIDER PAN, FW15 GREASE DEFL.RET.BRKT.
Fry Warmer Replacement Parts FW-12T (Side Breather) PART # WB31204100 C0119 CS0005 M0093 FB31203403 QTY 1 1 1 1 1 DESCRIPTION BLOWER PAN FW-12 WELD CALROD, 120V 1000W 140C C/U SWITCH CORD SET, 115V 7'6" MOTOR BLOWER ASSY 120V PAN RETAINING BRKT FW 20
Fry Warmer Replacement Parts FW-15T (Bottom Breather) PART # C0119 CS0005 M0093 FB31203403 WB31207500 QTY 1 1 1 1 1 DESCRIPTION CALROD, 120V 1000W 140C C/U SWITCH CORD SET, 115V 7'6" MOTOR BLOWER ASSY 120V PAN RETAINING BRKT FW PER PAN INSERT W/4" SHIELD FW15 21
Fry Warmer Replacement Parts FW-15DTO (Bottom Breather) 22
Fry Warmer PART # B0066 C0119 C0080 CS0005 FB31204803 LH0021 M0093 FB31203403 WB31207500 Replacement Parts QTY 1 1 2 2 1 1 1 1 1 DESCRIPTION BULB, 40A15 130V TEFLON COATED CALROD, 120V 1000W 140C C/U SWITCH CALROD, 120V 400W CERAMIC CORD SET, 115V 7'6" DIVIDER PAN FW CUF LAMPHOLDER, #62602 HI TEMP MOTOR BLOWER ASSY 120V PAN RETAINING BRKT FW PER PAN INSERT W/4" SHIELD FW15 23
Fry Warmer Replacement Parts Accessories PART # WB31216000 DESCRIPTION COUNTER TOP COLLAR WELDMENT WITH LINER PAN ATTACHED, BOTTOM BREATHER FW WB31211900 COUNTER TOP COLLAR WELDMENT WITHOUT LINER PAN ATTACHED, BOTTOM BREATHER FW WB31217700 COUNTER TOP COLLAR WELDMENT FW TOWER W/PAN LINER, BOTTOM BREATHER AN3121460S FW HEATER MOTOR ASSY (BAY MOTOR) WN31206400 TABLE TOP ADAPTER FW-12 WN31206500 TABLE TOP ADAPTER FW-15 24 PICTURE
Fry Warmer Wiring Diagrams Wiring Diagrams FW-12/FW-15 (Side Breather) 25
Fry Warmer Wiring Diagrams FW-12/FW-15 (Bottom Breather) 26
Fry Warmer Wiring Diagrams FW-15 (220V England) 27
Fry Warmer Wiring Diagrams FW-12T/FW-15T 28
Fry Warmer Wiring Diagrams FW-15DTO (Bottom Breather) 29
Fry Warmer Wiring Diagrams 30
Fry Warmer Notes Notes 31
Fry Warmer Notes 32
Fry Warmer Notes 33
P.O. Box 80400, Simpsonville, S.C. 29680-0400, USA http://www.bkideas.com Made and printed in the U.S.
