Manual

TEMP CONTROL

(80°F - 104°F/26°C - 40°C)

The last measured water temperature is

constantly displayed.

The water temperature displayed is current only when the

pump has been running for at least 2 minutes.

On panels with a single “Temp” or “Set” button, to display

the set temperature, press the button once. To change the

set temperature, press the button a second time before the

display stops ﬂashing.

Each press of the button will continue to either raise or

lower the set temperature. If the opposite direction is

desired, allow the display to revert to the current water

temperature. Press the button to display the set temperature,

and again to make the temperature change in the

desired direction.

VS/GS Panel -- 300 & 500 Series and Operation

Initial Start-up

Your spa will enter Priming Mode ( ) when it is energized.

During Priming Mode, press “Jets” button(s) repeatedly and

be sure all pumps are free of air. Priming Mode lasts less

than 5 minutes. Press “Temp” to exit. After Priming Mode,

the spa will run in Standard Mode (see Mode section).

Some panels may not have a “Temp” button. On these

panels the “Set,” “Warm,” or “Cool” buttons are used.

The pump responsible for heating and ﬁltration (pump 1

low-speed on non-circ system, or the circ pump on circ

systems) will be referred to simply as the pump.

In multi-button sequences, if the buttons are pressed too

quickly in sequence, they may not register.

Warm Cool Mode Jets Blower Light

Warm Cool Mode/Prog Jets Blower LightTime

500SZ Series Panel

300/300F/500Z Series Panel

500DZ Series Panel

Note: Button shapes and labels may vary.

Please refer to the User Guides for additional information.

500 Z Series User Guide: P/N 40789 300/300F Series User Guide: P/N 40839 (for systems with software V38 only)

500 SZ Series User Guide: P/N 40790 300/300F Series User Guide: P/N 40887 (for systems with software v41 only)

500 DZ Series User Guide: P/N 40788