Electric Company Water Heater User Manual

2-26 Installation & Operation MN1800
LSX Series Single Bearing Position Stage
General Description: Single axis linear stage with linear motor, linear bearings, magnetic encoder, limit
switches, cable carrier and bellows
Construction: Hard anodized aluminum
Bearing type: Recirculating ball type linear bearing
Encoder type: Magnetic
Motor type: Brushless three phase, iron core linear motor. Refer to catalog for motor specifications
and stage model number description.
Maintenance: Refer to bearing and encoder maintenance recommendations in this manual. Exterior of
stage should be kept dry and relatively free of contamination. This stage is NOT WATER
PROOF. Avoid submersion.
Stage specifications: Refer to catalog or outline drawing supplied with stage for mechanical dimensions.
Stage Mounting: Two parallel “T” slots on surface opposite of slide. Insert drilled and tapped steel rod .
ELECTRICAL CONNECTIONS (cables labeled accordingly)
Encoder: Refer to Elgo Mix 5 series magnetic encoder connections in this manual (Elgo Mix 4 is
optional).
Motor/hall/limit switches: Your stage has flying leads 10 foot in length. These cables can be cut if required.
Connectors are available, contact Baldor for more information.
AY1763A00 Leadwire Connection
Motor Cable Hall Cable Limit Cable
Wire Color
Signal Name
LinDrive Trap
Signal Name Wire Color Signal Name Wire Color
Motor Phase A (U) Red Black Hall 1 White Limit + Output White
Motor Phase B (V) White Red Hall 2 Red Limit – Output Red
Motor Phase C (W) Black White Hall 3 Black Home Output Black
Motor Ground Green Hall Ground Green Limit & Home PWR * Brown
Thermal Switch+ Blue Hall +5VDC Brown Limit & Home GND Green
Thermal Switch– Orange
* Limit & Home power is +4 to +24VDC.
Note: Motor phasing is for LinDrive or MintDrive. Other controls may require different phasing (such as most trap
drives (U) Black, (V) Red, (W) White). Phase angle between phases is 120 degrees.
Leadwire Connection
Color Pin# Description
Green 1 A+
Pink 2 B+
Brown 3 C+
White 4 Hall1
5 N/C
Yellow 6 A–
Red 7 B–
Gray 8 C–
Black 9 Hall3
Red 10 Hall2
White 11 +5VDC
(Halls Brown)
12 N/C
Black 13 Encoder GND
(Halls Green)
14 Hall Shield
15 Encoder Shield
Outer shield to shell
(LinDrive side only).
1
2
3
4
5
11
12
13
14
15
Male (D Sub)
LXS (15 pin to flying leads)LSX to LinDrive (15 pin D Sub on each end of cable)
Color Pin# Description
Green 1 A+
Pink 2 B+
Brown 3 C+
White 4 Hall1
5 N/C
Yellow 6 A–
Red 7 B–
Gray 8 C–
Black 9 Hall3
Red 10 Hall2
White 11 +5VDC
(Halls Brown)
12 N/C
Black 13 Encoder GND
(Halls Green)
14 Hall Shield
15 Encoder Shield
LXS Connections (Female) LinDrive Connections (Male)
LD9103A00
LD9114A00
Color Pin# Description
Green 1 A+
Pink 2 B+
Brown 3 C+
White 4 Hall1
5 N/C
Yellow 6 A–
Red 7 B–
Gray 8 C–
Black 9 Hall3
Red 10 Hall2
White 11 +5VDC
(Halls Brown)
12 N/C
Black 13 Encoder GND
(Halls Green)
14
15