Electric Company Water Heater User Manual

General Information 1-3MN1800
Receiving Each Baldor motor is thoroughly tested at the factory and carefully packaged for
shipment. When you receive your motor, there are several things you should do
immediately.
1. Observe the condition of the shipping container and report any damage
immediately to the commercial carrier that delivered your motor.
2. Verify that the part number of the motor you received is the same as the part
number listed on your purchase order.
Storage If the parts are not put into service immediately, store them in a clean, dry and warm
location. If the storage location is damp or humid, the exposed metal surface of the
motors and windings must be protected from moisture. If the ambient temperature
decreases suddenly, condensation may form. Protect all parts from moisture.
Unpacking Each Baldor motor is packaged for ease of handling and to prevent entry of
contaminants.
1. To avoid condensation inside the motor, do not unpack until the motor has
reached room temperature. (Room temperature is the temperature of the room
in which it will be installed). The packing provides insulation from temperature
changes during transportation.
2. When the motor has reached room temperature, remove all protective wrapping
material from the motor.
3. The magnet track sections may come packaged in one or more boxes. Do not
flip any magnet track sections inside the box. Unpack the magnet track
sections one piece at a time. Place each section on a clean non–magnetic
surface away from other magnet track sections and any other ferrous material.
4. Always keep the magnet track sections at a safe distance from each other. If
the assemblies are to be left unattended for any period of time, precautions
should be taken to prevent accidents due to the strength of the magnets (it is
best to leave them in their packing material to prevent injury due to magnetic
attraction). Persons who will come in contact with this assembly while
receiving, transporting, storing, installing, disassembling or at any other time,
must be made aware of this danger.
Handling Be extremely careful. Keep in mind:
1. The magnetic attraction between the motor and the magnet assembly is
extremely high. Keep fingers and other body parts away from these objects to
avoid injury by this magnetic attraction.
2. Use proper care and procedures that are safe during handling, lifting, installing,
operating and maintaining operations.
Improper methods may cause muscle strain or other harm.
Repairs Baldor will not share any responsibility for damage caused by customer attempt to repair
or modify a motor. Consult Baldor for any service.
For further assistance please contact the factory:
Baldor Linear Motion Products
25026 Anza Drive
Santa Clarita, CA 91355, USA
(661) 257–0216 (phone)
(661) 257–2037 (fax)