User Guide Owner's manual
14
>> Add more products
Step 2 – Set up your product to the correct Option
If you use BeoRemoteOne for a new
product or for two or more products of the
same type, for example, two televisions and
commands from BeoRemoteOne can be
received by both products, BeoRemoteOne
must be able to recognise your products
individually. Therefore, you must set up
your product to one of the dierent product
Options using the Product Option menu.
Depending on your setup, you can select
whether or not you want the product to
react to commands from your
BeoRemoteOne.
For information about which Option to use,
see the guide for your television or music
system.
Note! If a Network Link product is intended
for operation with Beo4, you must set it up
as a ‘Beo4’ product instead. For more
information, see pages 16–18.
To give your product a specific Option using
BeoRemoteOne…
Point your remote control at the IR-receiver
of the product you want to Option
programme. The distance between the
remote control and the IR-receiver must be
maximum 0.5 metres.
Press to bring up Settings in
the BeoRemote One display
Press to bring up Advanced
Press to bring up Product
Option
Select if you want the product
to be IR responsive or IR
blind*
1
Select the active product, such
as BeoVision
Select a product Option*
2
for
your product, such as
BeoSound
Select Send and press the
centre button to store the
selected Option
LIST
Settings
Advanced
Product
Option
...
...
...
Send
1
*
Select IR responsive when you want your
product to react to commands from your
BeoRemoteOne and IR blind when you do
not want your product to react to remote
control commands.
2
*
In order to show the product Option, such
as BeoSound, in the BeoRemoteOne display
when you press LIST, you must add it to the
BeoRemoteOne LIST, see page 13.