User Guide User Manual

31
If PDC/VPS is set to On…
If you have PDC/VPS set to On in the
V.Tape’s Basic setup menu (see page
52-53), the recording procedure is
controlled by the PDC/VPS broadcasting
signals*.
Even though you have set PDC/VPS to
On, the method described to the right
of this page only applies if the PDC/VPS
broadcasting signals accompany the
station you want to record from. If
PDC/VPS is not broadcast with the
station, the method described on the
previous page applies.
Press to switch to Teletext
Call up the Teletext page listing TV
programmes, then…
Press to be able to program a
recording
A cursor appears over the title of the
first programme on the page…
Press to move the cursor to the
programme you wish to record
Then
Press to accept the programme
Press GO to store your recording
TEXT
RECORD
GO
GO
or
*PDC/VPS and Video Programming via
Teletext
The PDC/VPS facility ensures that a TV
programme accompanied by the Program
Delivery Control (PDC) or Video Programming
System (VPS) broadcasting signals will be
recorded in its full length – even if the
programme is delayed or prolonged! If
PDC/VPS is set to On, start and stop times are
controlled automatically on stations which are
broadcast with the PDC/VPS signals.
If PDC/VPS is set to Off instead of On,
recording will start and stop as programmed,
even if the program is delayed or prolonged.
A Teletext page with the Timer recording facility
activated – PDC/VPS signals are available.
On this page it is indicated that you have
accepted the highlighted programme for
recording.
If PDC/VPS is set to On and PDC/VPS
broadcast signals are available…
Alternatively, press
tt to move the cursor
The cursor highlighting the title of the
programme change into a status of your
recording, e.g.
30.JAN P13 ZDF OK?
Check the data, if it is not correct, use
ss or tt
to move the cursor and ▲ or ▼ to reveal the
correct data…
RECORD appears after the title of the programme
you have programmed for recording
To program more recordings, continue to select
programmes…