User Guide User Manual

EXTRA VIDEO EQUIPMENT
50
Registering extra video equipment
You can connect extra video
equipment to the AV socket* on the
back of the BeoVision Avant.
Any extra video equipment connected
to the AV socket must be registered
into the AV Source menu. Display the
different options and press GO once
you have found the option matching
the equipment you have connected.
*Note: Please refer to the section Expanding your
system, page 12 in the Setting-up guide for
further information about the AV socket.
Note: When you tune in to a TV station via your
decoder number 2, you must set the item Decoder
in the TV tuning menu to 2.
If only one decoder is connected to the BeoVision
Avant connect it to the socket marked Decoder –
not the AV socket.
Menu
1 Timer record
2 Timer play
3 TV list
4 Setup
Setup
1 Tuning
2 Sound
3 Picture
4 Stand
5 Source
6 Menu
7 Clock
8 V.Tape
The main menu
The Setup menu
The Source menu for the AV socket gives you the
following options to register the extra
equipment you may have connected to the AV
socket, select...
Non B&O V.Tape2… for a non-Bang & Olufsen
video tape recorder
V.Tape2… for a Bang & Olufsen video tape
recorder
S-VHS V.Tape2… for a Super-VHS video tape
recorder
DVD… for a DVD or CDV player
Decoder-2… for a second decoder
Special decoder… for a special decoder
Door camera… for a door camera (this option
only appears, if your TV is equipped with a
P-in-P module)
V.AUX… for other auxiliary equipment
AV
Non B&O V.Tape2
Press to call up the main menu
The main menu appears…
Press to call up the Setup menu, if
Sat is available Setup will be item 5
The Setup menu appears…
Press to select item 5, Source
The AV Source menu appears...
Press repeatedly to display the cue
for the video source you have
connected
Press to register the source
Press to remove the on-screen menus
MENU
4
5
EXIT
then
GO
then