Installation guide

Master Link setup
ISP router
The ISP (Internet Service Provider) router gives access to the Internet and is used as router for computers on the
LAN and for the BeoLink Gateway.
BeoVision 7-40
BeoVision 7-40 is the ‘video master’ in the Master Link setup and is set to option 2.
The TV is connected in the Master Link system with a Master Link cable from the Master Link socket to
a junction box.
- Rerouting
The re-routing of light and controls commands to BeoLink Gateway must be enabled in BeoVision 7-40.
The re-routing should be enabled in the ‘Customer Service Menu’ [Adjustment].
- MLGW Command:
Must always be enabled when a BeoLink Gateway is connected on the Master Link system. Enabling the
MLGW Command allows light and control commands - from Beo4/Beo6 - to be rerouted to the BeoLink
Gateway.
- MLGW Status:
Must be enabled only if the Home Automation System connected is equipped with a display. Enabling the
MLGW Status allows display information to be shown in the display on the Home Automation System
panel.
BeoSound 4
BeoSound 4 is the ‘audio master’ in the Master Link setup and is in option 0.
BeoSound 4 is connected in the Master Link system with a Master Link cable from the Master Link socket to a
junction box.
BeoSound 4 is only able to work with the Home Automation System because it is connected via a ‘master’
(BeoVision 7-40 ) when it is in option 0. BeoSound 4 In option 0 acts as Source Center to the TV, and audio
sources played via the TV is controlled through the TV.
BeoSound 4 in option 1 or 2 is able to work on it’s own with a Home Automation System.
Link room products
- BeoVision 7-32
BeoVision 7-32 is working as a Link Room product and is in option 6. It is connected in the Master Link
system via a Master Link cable from the Master Link socket to a junction box.
- Rerouting
The re-routing of light and controls commands to BeoLink Gateway must be enabled in BeoVison 7-32.
The re-routing should be enabled in the ‘Customer Service Menu’ [Adjustment].
- MLGW Command:
Must always be enabled when a BeoLink Gateway is connected on the Master Link system.
Enabling the MLGW Command allows light and control commands - from Beo4/Beo6 - to be rerouted to
8