Installation guide

Service Menu’ [Settings].
The hostname for the BeoLink Gateway must be entered, for instance ‘BLGW’.
NL/ML Delay Box
A delay box is mounted in the Master Link system to prevent echo-effects (delay) between the Network Link
product and the Master Link products in Link Room. The delay occur because the audio
signals are converted from analog signals on the Master Link to digital signals on the Network Link.
BeoPlay V1 in a Link Room
BeoPlay V1 is connected to the Ethernet switch via CAT7 cables connected to the Ethernet socket on the TV
and a port on the Ethernet switch. BeoPlay V1 is in option 2.
- Rerouting
The re-routing of light and controls commands to the BeoLink Gateway must be enabled in the TV.
The re-routing should be enabled in the ‘Customer Service Menu’ [Settings/Re-route Light/Control].
- ‘Reroute Light/Control’ must be set to ‘BLGW’, when a BeoLink Gateway is connected on the
Network Link system. Enabling the Reroute Light/Control allows light and control commands - from
Beo4, Beo6, BeoRemote One - to be rerouted to the BeoLink Gateway.
BeoLab 3500 in a Link Room
BeoLab 3500 is in option 6 and connected in the Master Link system via a Master Link cable from the
Master Link socket to a junction box.
- Re-routing
To activate the re-routing of light and control commands to the BLGW in BeoLab 3500 is done in the
following way with Beo4/Beo6.
- [Menu]
- [Menu]
-[0]
-[5]
- [GO] ‘BLGW off’ Current state displayed
-[∧] ‘BLGW on’ - (Rerouting enabled)
-[∨] ‘BLGW off’ - (Rerouting disabled)
- [GO] Store setting
- [Stop] Exit (or after 3 sec. time out)
Home Automation System
The home Automation System is, for the communication with the BeoLink Gateway, connected to a port
on the switch with a CAT7 cable.
BeoLink Gateway
BeoLink Gateway is connected to the Ethernet switch with a CAT7 cable from the Network Link socket to a
port on the Ethernet switch.
The commands (‘EVENTS’), from the products on the Network Link/Master Link, and commands (‘EVENTS’)
from the Home Automation System are ‘mapped’ (listed) in the BeoLink Gateway. The BeoLink Gateway
‘COMMANDS’ are also ‘mapped’.
When a macro is triggered by an ‘EVENT’ the BeoLink Gateway transfers the associated ‘COMMANDS’ via
the Network Link/Master Link to the B&O products and/or via the Ethernet/RS232 to the Home Automation
System. (See Basic functionality).