Installation guide

LED System Status

BeoLink Gateway is equipped with an LED indicator, which is used to display the system status of BeoLink

Gateway. The LED, placed at the lower part of the connection panel, is also used to give feedback when the

Setup button is operated.

LED Indicator

Solid green - Normal operation

Quickly - green/red loop - Critical error

Solid red - H8 / FEP or FPGA upgrade

Flashing green - slowly - Software upgrade / System boot

Flashing red - slowly - Master Link synchronization

Setup Button functions

The Setup button, providing several functions during normal operation, is placed at the lower part of the

connection panel.

Function 1: System event - Executing macros with EVENT.

Function 2: Reset password to default - ‘Password’ to factory default (admin).

Function 3: Fixed IP-address - Enables the default IP-address (192.168.1.10).

Function 4: Factory default - Erases all configuration and settings.

Function 5:

Function 6: Dynamic IP-address - Enables DHCP - dynamic IP-address.

Select a function

Press and hold the setup button and the system will cycle through the functions. The LED indicator lights red and

indicates the function number by flashing - function no 1 = one flash, function no 2 = two flashes,

3 = flashes,etc.

When the desired function is reached the button should be released and the LED indicator starts to flash red.

To confirm the function execution the setup button should pressed again within 3 seconds.