Installation guide

Systems
The systems settings is for setting-up systems connected to BeoLink Gateway.
BeoLink and Home Automation systems are ‘systems’.
System settings
Select ‘+’ to add a new system. Any of the supported systems can be added, except internal systems, which only
appear once in the installation, such as BeoLink and Virtual Resources. BeoLink and Virtual Resources are
added by default.
It is possible to change zone, rename the system, and to adjust the configuration and connections settings of the
system. The systems have to be assigned to zones, but several of the systems affect or have resources
throughout the house.
Systems are invisible to the users. They will have access to resources and macros, not systems. Resources and
macros are distributed into the corresponding zones.
Assigning systems to zones is for the installer.
Place the system in the zone where the control/interface hardware such as BeoLink Gateway hardware,
network interfaces for lighting control systems and controller hardware are located.
System status icons
Connection status for each system icon is added at the bottom of the screen. The icons is a quick status
indication by means of a color code and a pop-up message under the mouse pointer.
If a system cannot connect the system logs should be checked for information about the problem.
23