Owners manual

96444 v.3.0 15
31. Once a location has been
determined for the Super-Scoop, mount
it using one of the methods outlined
below.
The Banks Super-Scoop may be mounted
by several means. If the grille consists
of horizontal bars or a perforated metal
screen heavy enough to support the
inductor, it may be secured using four
14” nylon cable ties, provided, slipped
through the ears on the Scoop and
through the grille. See Figure 14.
An alternate method is to mount the
inductor using the four perforated metal
straps provided. These can be bent as
required and attached to the Scoop’s
ears with the
1
⁄
4
20 x 1
1
⁄
4
hex bolts,
1
⁄
4
-20 nylock nuts and
3
⁄
4
O.D. x
5
⁄
16
I.D.
flat washers provided. The opposite
end of the straps may be attached to
any convenient mounting points such
as the gravel pan, grille brackets, etc.
as required, with four No. 10 x
3
⁄
4
” sheet
metal screws provided. A combination of
cable ties and scraps may also be used.
Connect the fresh air inlet on the air filter
housing to the Super-Scoop using the
4” diameter flex hose provided. Cut the
hose to the desired length using a knife
and diagonal cutting pliers. Secure with
No. 64 hose clamps.
32. Check over the entire installation for
loose clamps or bolts, hoses and wiring too
close to hot or moving parts, sharp edges,
etc., and correct as necessary.
33. Reconnect battery cables. Reinstall
engine “dog house” cover. Remount tires,
if removed.
34. Start engine and listen for any exhaust
leaks. Tighten bolts or clamps to correct
leaks as required. Allow engine to warm up
and test drive vehicle.
NOTE: Exhaust tubing will smoke for the
first 15 to 20 minutes of operation. This
is normal, as grease used in the bending
process will burn off the inside of the pipes.
35. Three Banks PowerPack® plaques
have been included in your kit. These may
be affixed to your vehicle by pealing off the
backing and pressing firmly in the desired
location. A piece of masking tape applied to
the vehicle with reference measurements
to other emblems or body trim may be
used to level and locate your plaques.
Suggested locations for plaques shown in
Figure 15 on last page of manual.
36. For California vehicles, apply the CARB
sticker, supplied, to an under-hood location
near other tune-up information.
FIGURE 14