Manual

P.N. 96312
3
GENERAL INSTALLATION PRACTICES
For ease of installation of your Banks Stinger
™
System,
please read this 8-page owner’s manual before starting
any work. (If any pages are missing from this package, please
call Gale Banks Engineering immediately for a replacement.)
Become thoroughly familiar with all components and phases of
the installation before starting any work.
Inspect all components supplied for any foreign material
that may have entered during shipping & handling.
WARNING! NEVER work under any vehicle
supported only by a jack of any kind. DO
NOT USE concrete blocks or other masonry items
that may collapse under the vehicle weight.
Pay particular attention to the routing of wires and
hoses. Keep them away from exhaust heat, moving
parts and sharp edges that may cause cuts or other damage.
Route or tie away from critical areas as required. Keep all
wires a minimum of 6" from hot exhaust parts, 8” or more is
recommended whenever possible.
Right-hand and left-hand designations refer to the driver’s
right or left, as seated in the vehicle (i.e.: Right-hand refers
to the passenger side of the vehicle), unless noted otherwise.
5.
4.
3.
2.
1.