User Manual

12. Slide one (1) of the supplied
4-inch exhaust clamps over the Banks
intermediate pipe.
Note: On extended-cab long-bed and
crew-cab long-bed vehicles, the clamp
that is used between the intermediate
pipe and muffler is a combination
hanger/clamp. When this hanger clamp
is installed the hanger pin should be
inserted into the factory rubber hanger
and the clamp should be rotated until
the hanger pin is parallel with the frame
mounted pin before being torqued.
13. Install the muffler onto the end
of the intermediate pipe outlet. Be
sure that the inlet side of the muffler
(see markings on muffler body)
is facing toward the front of the
vehicle. Orient the muffler such that
the “Banks Monster” logo is facing
towards the frame and is level with
the ground. Verify that the muffler
and intermediate pipe are completely
engaged.
Figure 2
2001-2005 Chevy/GMC 6.6L
Duramax
Cut Flanged
Intermediate
pipe to Length
Standard Cab/
Long Bed
No Cut
Extended Cab/
Short Bed
9
1
⁄2”
Extended Cab/
Long Bed
9
1
⁄2”
Crew Cab/
Short Bed
No Cut
Crew Cab/
Long Bed
No Cut
Table 1
96568 v.1.0 7