User Manual

14. Slide one (1) of the supplied
4” exhaust clamps onto the Banks
Monster muffler outlet.
15. Install the tailpipe into the outlet
of the muffler. Be sure that the two
pipes are completely engaged. Insert
the front and rear tailpipe hanger pins
into the factory rubber hangers. Rotate
the tailpipe until the hanger pins are
parallel with the frame mounted pin.
Note: If installing optional tailpipe
tip, cut off 4” from the tailpipe outlet
before installing the tailpipe into Banks
Monster Muffler. See Figure 3.
Minimum distance between exhaust tip
and body is one (1) inch.
16. Adjust each of the pipes to ensure
that all of the hanger pins are parallel
with the frame mounted pins and that
the rubber hangers are all positioned
slightly forward (See Figure 4). The
amount of forward angle on the rubber
hangers should increase the farther
downstream the hanger is positioned.
This allows the hangers to be properly
positioned once the exhaust system
reaches operating temperature.
17. Install the exhaust clamp at each
of the three (3) joints.
Figure 5 illustrates the proper location
of an exhaust clamp on a tubing
joint. Torque the nuts on each of the
exhaust clamps to 35 ft-lb.
Note: If a combination hanger/clamp is
utilized, evenly torque nuts to 35 ft-lb.
The clamps only need to be tight
enough to form a seal and hold the
pipes together. Over tightening the
clamps may cause the system to leak
due to the pipe being crimped.
8 96568 v.1.0
Figure 3 If Installing Optional Tailpipe Tip
Tailpipe Outlet