User Manual

4 96768 v.8.0
Dear Customer,
If you have any questions
concerning the installation of
your Banks High Ram Intake,
please call our Technical Service
Hotline at [phone]
between 7:00 am and 5:00 pm
(PT). If you have any questions
relating to shipping or billing,
please contact our Customer
Service Department at
[phone].
Thank you.
1. For ease of installation of your
Banks High-Ram Intake, please
familiarize yourself with the
procedures by reading the entire
manual before starting work.
2. Disconnect the ground cable from
the battery before beginning work. If
there are two batteries, disconnect
both.
3. Route and tie wires a minimum
of 6 inches away from exhaust heat,
moving parts and sharp edges.
Clearance of 8 inches or more is
recommended where possible.
4. The installation should be
performed at time when the vehicle
has been allowed to completely cool.
This installation requires the installer
to work near surfaces that may remain
hot after the vehicle has been run.
Failure to allow the vehicle to cool
may result in personal injury.
5. During installation, keep your work
area and components clean to avoid
possible dirt entry into the engine.
6. Banks recommends that a
Pyrometer (EGT) gauge (Banks part#
63401) and a Boost gauge (Banks
part# 63405) be installed to monitor
performance and exhaust gas
temperature of the vehicle.
Tools Required:
• Inch and metric combination or
open-end wrenches
• Standard and flat head screwdrivers
• Torque wrench (lb-in)
• Gasket scraper
General Installation Practices