User Manual

26 97055 v.8.0
1. Remove the fuse box cover, located
in the front driver’s side of the engine
compartment. Locate mini-fuse #50
for 2004-05 trucks (Figure 26) or
#28 for 2006-07 trucks (Figure 27)
and remove it.
2. Install the mini-blade fuse tap onto
the removed mini fuse as shown in
Figure 28. Re-install the mini fuse
with the attached blade tap into fuse
box.
For 2004-05 trucks, install the fuse
tap in the #50 spot closest to the
firewall as seen in Figure 26.
For 2006-07 trucks, install the mini-
auto blade tap in the #28 spot closest
to the engine. This is the “hot” side of
the circuit. See Figure 27.
3. Cut a small notch in the fuse box
cover and base to avoid a pinched or
stressed wire.
For 2004-05 trucks, cut the notch at
the edge closest to the firewall. See
Figure 29.
For 2006-07 trucks, cut the notch at
the edge closest to the engine. See
Figure 30.
NOTE: If a Banks Six-Gun or OttoMind
Diesel Tuner has been installed in the
vehicle, disconnect the Tuner’s red
Power Terminal wire from the fuse tap
and connect the CBC/SmartLock’s red
Fuse Connector wire from the Banks
Exhaust Brake Harness. Connect the
Tuner’s Power Terminal wire to the
Exhaust Brake Harness, (optional)
Tuner Power Connector. See
Figure 4.
Figure
26 2004-2005 Models
Section 6
CBC/SmartLock and Wiring Harness Installation