User Manual

97055 v.8.0 39
2006-2007 Switch install
9.
Remove the lower dash knee panel
from the vehicle by removing the two
(2) screws at the bottom corners of
the panel (retain for re-installation).
There are also two (2) retaining clips
located at the top corners of the
panel, which hold the panel in place.
These clips can be released by gently
pulling on the corners of the panel.
Use caution to avoid damaging the
panel during removal.
NOTE: If your vehicle is equipped with
power adjustable pedals, remove the
power adjustable pedal switch wiring
connector from the rear of the panel
and move the panel aside.
On vehicles with a center console,
it may be necessary to remove the
console to ease removal of the lower
dash panel.
10. Cut out one of the supplied
templates (Figures 50, 51) and align
the template above the brake release
lever (Figure 44). If applicable, align
the template next to the power
adjustable pedal switch (Figure 45).
Place the template’s bottom edge
against the top edge of the brake
release trim. Use masking tape to
securely hold down the template.
Note: Do not tape over the markings
on the template.
All Year Ranges
11.
Before drilling, double check
to make sure there is enough room
behind where the Banks Brake Enable
Switch will be located. It may be
necessary to make minor adjustments
to the switch’s location, as needed.
Choose one of the hole locations that
you would like to drill. Using a ½” Uni-
bit, center the bit onto the ½” drill
location on the template and slowly
drill through the panel. Remove and
discard the template and any plastic
shavings.
Figure 44 2006-07 Models Brake Release Location