User Manual

40 97055 v.8.0
NOTES: It is important that the hole
is drilled as close as possible to the
recommended location. The switch
may not clear the instrument panel
structure if the hole is shifted to
another location.
A pilot hole may be drilled first if a Uni-
bit is unavailable. Use a drill bit smaller
than
1
/2”.
12. Align the Banks CBC/SmartLock
Enable Switch label and the Overdrive
Disable label over the previously drilled
hole. Make sure the entire mounting
surface is clean and free of dirt and
oil before mounting the label. Clean
and dry as required using a cloth
dampened with rubbing alcohol or
similar cleaning solution.
CAUTION: Do not get any fluid
directly onto/into any electrical
equipment or equipment damage
may result.
13. Mount the Banks CBC/SmartLock
Enable Switch label and the Overdrive
Disable label onto the panel by peeling
off the protective backing from the
adhesive tape on the back of the
switch label. Hold the label against the
panel for approximately 20 seconds
while applying pressure to allow the
adhesive to properly adhere to the
surface.
14. Attach the Brake Enable Switch
wires to the Switch (BLACK to 1,
BLACK-RED to 2, RED to 3). See
Figure 46.
15. The wire colors for the Overdrive
Disable Switch will be the same,
except for connection wire #2
(Figure 47). Wire #2 will be BLACK-
WHITE. Attach the Overdrive Disable
Switch wires the same as the Brake
Enable Switch.
Figure 45 2006 Models Power Adjustable Pedal Switch Location