User Manual

15. Install the supplied
actuator pressure hose, being
careful to route it safely away
from close contact with heat,
moving objects and sharp
surfaces. Secure it using
the two (2) supplied spring
clamps.
16. Double-check that any
shop towels or rags in the
compressor outlet and inlet
tubes have been removed.
Re-install the compressor
outlet tube, air filter housing,
and compressor inlet tube.
Tighten all clamps and
mounting bolts.
17. Start the engine and
allow it to warm up. Drive
the vehicle, listening for any
exhaust leaks or rattles.
Adjust and tighten any
clamps removed during
the installation process if
necessary.
Gale Banks Engineering
546 Duggan Avenue • Azusa, CA 91702
[phone] • Fax [phone]
Product Information & Sales: [phone]
bankspower.com