User guide

ManualsBrandsBanks Power ManualsToolsDynaFact pillar-style gauge mount '99-03 Ford 7.3L Power Stroke Trucks

05/18/05 PN 96414 v.1.0

Banks DynaFact

Pillar-Style

Single Gauge Mount

1999-2003 Ford 7.3L Power Stroke Trucks

FOR USE WITH 63217

Gale Banks Engineering

546 Duggan Avenue • Azusa, CA 91702

(626) 969-9600 • Fax (626) 334-1743

roduct Information & Sales: (800) 438-7693

Customer Support: (888) 839-5600

Installation Support: (888) 839-2700

bankspower.com

Owner’sManual

with Installation Instructions

Summary of content (8 pages)

PAGE 1
with Installation Instructions Owner’sManual Banks DynaFact® Pillar-Style Single Gauge Mount 1999-2003 Ford 7.3L Power Stroke Trucks FOR USE WITH 63217 Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334 -1743 Product Information & Sales: (800) 438-7693 Customer Support: (888) 839-5600 Installation Support: (888) 839-2700 bankspower.com ©2005 Gale Banks Engineering 05/18/05 PN 96414 v.1.
PAGE 2
General Installation Practices Tools Required: Dear Customer • 3⁄ 8” socket, extension and driver If you have any questions concerning the installation of your Banks DynaFact® Pillar-Style Gauge Mount, please call our Technical Service Hotline at (888) 839-2700 between 7:00 am and 5:00 pm (PT). If you have any questions relating to shipping or billing, please contact our Customer Service Department at (888) 839-5600. • 5⁄ 32” hex key Thank you.
PAGE 3
Installation Instructions Note: Due to normal manufacturing processes you may have “flashing” (small fibers of plastic) around the pod holes. Once the gauge(s) are installed in the pod you will not be able to see the flashing. This mount is designed to hold gauges with a press or friction fit. To allow you flexibility in the positioning of your gauges, all of the holes are cut to the same size. Oil temperature gauges and boost gauges should fit into this mount with no modification.
PAGE 4
3. Fit single gauge pod to A-pillar 5. Create an opening in the A-pillar mould. See figure 2. moulding for gauge wires to pass through. 4. Mark position of single gauge pod on A-pillar moulding. Figure 2 STEP 3 STEP 9 4 96414 v.1.
PAGE 5
6. Test fit the gauge pod with the gauge installed on the A-pillar to ensure clearance for gauge lines and housing. See figure 3. 7. Run gauge lines out through the firewall toward the engine. 8. Install the gauge pod and A-pillar, ensuring that lines are not pinched. Figure 3 STEP 6 96414 v.1.
PAGE 6
STEP 3 9. Reinstall windshield side garnish to A-pillar moulding. See figure 4. 10. Connect the gauge(s) to the vehicle. Follow the instructions provided with the gauge(s) for proper installation and operation. Figure 4 STEP 9 6 96414 v.1.
PAGE 7
Notes 96414 v.1.
PAGE 8
Gale Banks Engineering 546 Duggan Avenue • Azusa, CA 91702 (626) 969-9600 • Fax (626) 334 -1743 Product Information & Sales: (800) 438-7693 Customer Support: (888) 839-5600 Installation Support: (888) 839-2700 bankspower.