User guide

42 97273 v.2.0
Section 20
GAUGE DESCRIPTIONS
Receive Update Notices
Banks iQ is constantly evolving and
new gauges in addition to the ones
described below may be available. We
invite you to register at
www.bankspower.com/banksiq
to receive important emails regarding
updates and upgrades for your Banks
iQ device.
Following is a list of the gauges you
can choose to be in your Banks iQ
display and what they measure.
NOTE: Not all gauges are accessible in
all Modes.
$ PER DAY: Displays the calculated
operational cost per day. Must enter
cost of fuel at fill up to get accurate
display.
$ PER TRIP: Displays the calculated
operational cost per trip. Must enter
cost of fuel at fill up to get accurate
display.
AIR FLOW: Displays the intake air flow
in lbs/min or g/sec.
AMB TEMP: Measures the temperature
of the air outside the vehicle in your
choice of degrees Fahrenheit or
Centigrade (F or C).
AVG ECON: Displays the average fuel
economy in miles per gallon (MPG) or
liters per 100 kilometers (L/100K) since
the last trip reset.
AVG SPD MOV: Calculates the average
speed while the vehicle is moving
since last reset.
AVG SPD TTL: Calculates the average
speed from trip beginning since the
last trip reset.
BARO: Measures the barometric
(atmospheric) pressure outside your
vehicle in inches of mercury (inHg).
CAT TMP 1F/2F: Displays the
temperature of the exhaust gas at
the inlet of the catalytic converter in
your choice of degrees fahrenheit or
centigrade (F or C).
CAT TMP 1R/2R: Displays the
temperature of the exhaust gas at
the outlet of the catalytic converter in
your choice of degrees Fahrenheit or
centigrade (F or C).
DIRECTION: Display your current
direction. NORTH (N), NORTHEAST
(NE), EAST (E), SOUTHEAST (SE), SOUTH
(S), SOUTHWEST (SW), WEST (W), AND
NORTHWEST (NW).
ELEVATION: Measures the elevation
you are driving at in your choice of
Feet or Meters above sea level (FT or
M).
NOTE: Elevation should be accurate
within +/- 50 feet or 15 meters 95%
of the time. On rare occasions, you
may experience a variance greater
than +/- 15 meters or 50 feet. This is
considered normal for devices of this
type.
ENG HOURS: Displays the amount of
engine on time since trip reset.
ENG LOAD: Displays calculated engine
load. This value indicates the amount
of available power at the current RPM
That is being used.
ENG TEMP: Measures the temperature
of vehicle’s engine coolant in your
choice of degrees Fahrenheit or
Centigrade (F or C).
EGR: Displays the position of the EGR
valve in percentage; 0% = fully closed,
100% = fully open.
FUEL>>EMPTY: Displays the amount of
fuel left before empty in your choice of
gallons or liters.
FUEL LEVEL: Measures the current fuel
level of your vehicle.