Specification

For concrete ceiling, use the percussion
bit with diameter 8mm to drill holes
according to the length of expansion
screws. Then use the attached expansion
screws to fix the hanging bracket onto
the ceiling (selection is made according to
actual requirements of the customers).
STEP 2 A-CONCRETE CEILING
1 )Use the Mounting Bracket (A) as a guide, mark the spots where the 4 Expansion Bolts
(B)will be drilled.
SWITCH OFF THE ELECTRICAL MAINS AT THE CIRCUIT BREAKER FUSE BOX.
2 )Remove the Mounting Bracket (A), drill 4 holes and insert 4 Expansion Bolts (B)into the
concrete ceiling, install the mounting bracket and secure with Flat Washers (C), Spring
Washers (D) and Nuts (E).
IMPORTANT : SCREWS & NUTS MUST BE TIGHTENED TILL SNUG
Expansion Bolts
Flat Washers
Nuls
Mounting
Bracket
CÖNCRETE CEILING
Flat Washers
07
Installation of the hanging bracket
(suspension part)(page-2)