Specification

09
Assembly - Hanging the Fan
Install downrod assembly
Hang the fanHang the fan
Install canopy
□ Carefuly feed the molor wires up though the downrod
□ Align the holes and replace hanger pin and locking pin.
□ Tighten the two colar setscrews.
□ Slip coupling cover,canopy coverand canopy onto the downrod.
□ Lift the fan motor assembly up to the mounting bracket and
seat the hanger ball in the mounting bracket socket.Rotate the
fan motor assembly until the check groove drops into the regi-
stration slot and seats firmly.The downrod should not rotate if
the is done correctly
□ Ensure the loosened screws is inserted into the key holes on
the mounting bracket.
□ Carefully raise the canopy up to the mounting bracket.Rotate
the canopy clockwise.
□ Secure the canopy by replacing the screws previously removed
and tightening the screw previously loosened
□ Place the canopy cover (if applicable)and rotate the canopy
cover clockwise until it locks into position.
E
F
G
H
I
Slide - on mounting bracket
(inside canopy) X 1PCS
Canopy X 1PCS
9.84 inch Ball/downrod assembly X 1PCS
4.92 inch Ball/downrod assembly X 1PCS
Coupling cover x 1PCS
A
Fan-Motor assembly ×1PCS