Installation Guide

ManualsBrandsBANSA ROSE ManualsBathSingle-Handle Floor Mount Freestanding Tub Faucet with Hand Shower in Matte Black

Pre-Installation (continued)

PACKAGE CONTENTS

HOMEDEPOT.COM

Please contact 1-855-HD-GLACIER for further assistance.

Part Description Quantity

A 1

B Set screw 1

C Mixer 1

Spout

D 1

E Escutcheon 1

Standpipe

Part Description Quantity

F 3

G Anchor 3

H Showerhead 1

Screw

I 1Shower hose

J 12.5mm Hex wrench

Summary of content (4 pages)

PAGE 1
Pre-Installation (continued) PACKAGE CONTENTS A J B C H D I E F G Part Description Quantity Part A Spout 1 F B Set screw 1 Description Quantity Screw 3 G Anchor 3 Showerhead 1 C Mixer 1 H D Standpipe 1 I Shower hose 1 E Escutcheon 1 J 2.5mm Hex wrench 1 3 HOMEDEPOT.COM Please contact 1-855-HD-GLACIER for further assistance.
PAGE 2
Installation 1 Preparing for installation 2 Installing the escutcheon □ CAUTION: Always shut off the water supply before removing an existing faucet or replacing any part of a faucet. Open the faucet handle to relieve water pressure and ensure that the water is completely shut off. □ Shut off the water supply. Remove the old faucet. Clean the surface in preparation for the new faucet. □ Loosen the set screw (B) pre-assembled to the spout (A) with the Hex wrench (Hex: 2.
PAGE 3
Installation (continued) the mixer to the 3 Screwing standpipe the holes & Making the 4 Drilling waterline connections NOTE: Do not reverse the hot and cold supply. □ Screw the standpipe (D) onto the mixer (C) by hand. Turn in a clockwise direction until it is tight. □ Mark the locations for the screws with a pencil (1). With an electric drill (2), drill three 1/4 in. diameter holes for the screws in the floor. Place the anchors (G) into the holes.
PAGE 4
Installation (continued) 5 Securing the faucet assembly 6 □ Ensure the standpipe (D) sits flush against the finished floor surface. Then secure the standpipe (D) using screws (F). □ Push the escutcheon (E) over the standpipe (D) base so that it sits flush against the finished floor surface. Connecting the shower hose □ Connect one end of the shower hose (I) to the mixer (C) and the other end to the showerhead (H). □ Ensure the washer (1) is placed into each end for seal.