Installation Guide

Installation

Preparing for installation

CAUTION: Always shut off the water supply before

removing an existing faucet or replacing any part of a

faucet. Open the faucet handle to relieve water pressure

and ensure that the water is completely shut off.

□ Shut off the water supply. Remove the old

faucet. Clean the surface in preparation for

the new faucet.

□ Loosen the set screw (B) pre-assembled to the

spout (A) with the Hex wrench (Hex: 2.5mm, J),

rotate the spout (A) about 90° to face the spout

(A) towards the front, then tighten the set screw

(B) with the Hex wrench (Hex: 2.5mm, J).

Installing the escutcheon

□ Place the escutcheon (E) over the standpipe (D)

and push it to the base.