Installation manual

3-7
5975968A RETRO DATA 2100LC 130298
Power Up Considerations
FRONT CONTROL PANE
L
+
+
+
+
+
0
9
7
8
6
5
4
3
2
1
+
BALANCE
+
+
VOLUME
+
BASS
+
CONTRAST
TREBLE
BRIGHTNESS
COLOR
TINT
SHARPNESS
ADJ
FREEZE
MUTE
PHASE
EXIT
PAUSE TEXT
STBY
ENTER
ADDR
REMOTE CONTROL PANEL
HELP
Stand-By button
Power Switch
Projector Status LED
ENTER displays the Change Password menu
EXIT returns to the adjustment selection menu.
The old password is displayed and can be changed by entering the
digit with the numeric keys of the RCU or local keypath.
Press ENTER to save the new entered password.
Press EXIT if no changes have to be made.
Select with or
then <ENTER>
<EXIT> to return.
Highlight Change password by pressing the control disc up or down
and then press ENTER to display the Change Password menu.
Projector status LED
No light up : projector switched off
Green color : projector in Operational mode
Red color : projector is in Stand-by mode.
To start image projection, press the 'Stand by' button on the front local
control keypad or on the remote control. The projector mode status
LED lamp will be green.
When switching 'on' with the power switch, the projector starts in
the stand by mode. The projector mode status LED lamp is red.
Switching off
To switch off:
- press firstly the STAND-BY key and allow projector to cool down
until the fans stop blowing (or at least 15 min).
- then switch off the projector with the power switch on the front local
control panel.
Switching on
Use the power switch to switch on the projector, using the switch
on the front local control panel.
When '0' is depressed, the projector is switched off.
When '1' is depressed, the projector is switched on.
The projector is switched ON and OFF using the power (mains)
switch ON/OFF on the front local control panel keyboard
To gain access to the keyboard, refer to 'Front local Control panel
description and function' in chapter 1 'Location and function of
control'.
1 Pressed : ON
0 Pressed : OFF
Switching to stand-by
When the projector is running and you want to go to stand-by, press
the stand-by key.
Caution : Before powering down the projector, switch the projector
to stand-by and let the projector lamp cool down until the fans stop
blowing (or for at least 15 minutes).
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUN TIME
LAMP RUN TIME HISTORY
PRESET INPUT BALANCE
MORE ...
CHANGE PASSWORD
Enter new password
0000
Select with or
then <ENTER>
<EXIT> to return.