Installation manual

3-2 5975968A RETRO DATA 2100LC 130298
Power Up Considerations
Attention
Follow the procedure as described below, it is recommended that a
qualified Barco technician performs the alteration of the password
function.
It will be necessary to remove the front, rightside and leftside
panelling, plus the associated strengthening supports of the lower
projector cabinet, by either loosening or removing their fixing nuts.
WARNING : Power down all devices and switch off, discon-
nect all the input/output connectors to the projector. Unplug
the power cord from the rear of the retro projector and lock
the retro projectors rear positioning wheels.
I
Removing the Projector
,a. The front panel needs to be removed and this is achieved by
firstly opening the front control panel and gaining access to the two
large locking screws on either side of the control panel. Unlock by
turning one half turn counter clockwise. The front panel can now be
released from its mountings by tilting forwards slightly, then lifting
upwards and outwards (the front control panel should remain in the
open position at all times.)
WHEEL
POSITION LOCK
'OFF'
WHEEL
POSITION LOCK
'ON'
ê
PRESS
ý
þ
Disconnect
Power cord
û
POWER / M
A
a
FRONT
PANEL LOCKING
SCREWS

FRONT
PANEL
FRONT
CONTROL
PANEL
It is necessary to remove the projector from the lower cabinet to
perform the changing of the pass word function. Follow the procedure
for 'Removing the Projector' next.
Enabling/Disabling the Password
Tools Required
Phillips screw driver (PH0)
Flat Top Screw Driver
Wrench, Spanner (N
o
- 7,8,10)