Installation & Assembly

BARN DOOR HARDWARE KIT
INSTALLATION GUIDE
Step 9. Floor-Mounted Door Guide
Installation
Once the door is plumb, position the floor-mounted door
guide inside the mortised door, line up close to the opening.
Slide the door side-to-side to ensure functionality for final
placement then mark holes with a pencil and pre-drill 5/16"
holes. If drilling directly into a concrete floor, use the
provided anchors.
30mm
Ø8
7mm
1 3/16''(30mm)
5/16''(Ø8)
1 63/64''(37
.5mm)
Step 10.Install right left close attachment
1.Push the door to the left, push it to the required position.
place the actuator connector in the middle of the actuator claw.
2. Insert the washers and tighten it with a wrench.
3. Push the door to the right and install the actuator on the connector.
4. Move the actuator claw to the right, adjust the actuator to a limited position.
adjust the height of the soft close, and make sure it works.
Rail
Door
1
2
3
Move the door.
6
5
Rail
Door
4
TSQ13BK-6FT+TKM04