Installation Guide

5
1
2
3
4
Panel/Post Installation
As the post is setting up, install the  rst fence panel.
Insert the horizontal rails from the panel into the
punched holes from the previously installed post. Place
the rails as far into the post as they will go (Fig. 1).
Fig. 1
Fig. 2
Place the next required post into the dug hole, and slide
the post onto the rails of the panel as far as possible.
Plumb and level the post and add concrete according to
manufacturer's instructions.
After setting  rst fence section, proceed systematically
with post, panel, post, etc. (Fig 3).
Fig. 3
Top view of post
Rail
Rail
Post
Fig. 4
After concrete has set, fasten the fence section to the
posts using #8 x 1" self-tapping screws (Fig. 4).
IMPORTANT:
Be careful not to over-tighten screws.