Operation Manual

EN
page 42
7. SIGNALS AND ALARMS
Thealarmsandthesignalsmessagesarevisualized,basedupontheirmeaning.
WhenonthedisplaytheLED"F" above the "K" keyashes,atotalregenerationisneeded
(onlywithoptionalwatersoftener).
Whenashing"NO DE"(alternatedtothetankandboilertemperaturesandwithmachine
onstand-by mode), add detergent inthedetergent tank (only with optional "Sensorfor
ChemicalsLowLevel").
Whenashing"NO RI"(alternatedtothetankandboilertemperaturesandwithmachine
onstand-bymode)addrinse-aidchemicalintherinse-aidtank(onlywithoptional"Sensor
forChemicalsLowLevel").
When displaying "NO SA"(alternatedtothetankandboilertemperaturesandwithmachi-
neonstand-bymode)addsaltinthecontainerinthewash-tank(onlywithoptionalwater
softener).
When displaying "DOOR" means that the open door does not allow the maneuver tried, or
a wash cycle was in progress, when lifting the door.
Table 3
TYPE OF ALARM CAUSE REMEDIES
B1 BOILERFILLINGFAIL
Open the water supply valve and verify a proper water
supplyow.ContactTechnicalService
B2 BOILERPROBEFAIL.
ContactTechnicalService
B3 BOILERHEAT.ALARM
ContactTechnicalService
B4 RINSINGFAILED
TIMEOUTRINSE
ContactTechnicalService
B5 BOILEROVERHEATING
ContactTechnicalService
E1 WATERLOADFAILED
Open the water supply valve.
ContactTechnicalService
E2 TANKPROBEFAIL.
ContactTechnicalService
E3 TANKHEATINGALARM
ContactTechnicalService
E5 TANKOVERHEATING
ContactTechnicalService
E6 TANKDRAININGFAIL.
Checktheoverowpipe.ContactTechnicalService
Z6 TANKLOWLEVEL Drain and load the tank.
ContactTechnicalService
Z9 REGENERATIONFAIL
ContactTechnicalService
Z10 ALARMSL8-BREAKTANKHIGH
LEVEL
ContactTechnicalService