Operation Manual

EN
page 26
1.9.2 Parameter programming
On entering parameter programming the message "P" and the parameter number followed
by the parameter value are displayed.
At this point it will be possible to:
Change the parameter value with the "K" (decrease) and "L" (increase) keys;
ConrmtheselectionbypressingtheStart "H" key.
Go to programming of the next parameter, by pressing the "H" key.
Return to the parameter selected without changing the data by pressing the "J" key.
The following parameters can be changed (see table 2):
1.9.3 Set "1" parameter
By the "K" (decrease) and "L" (increase) key, select the "1" BOILER TEMPERATURE
SETTING parameter
ConrmtheselectionbypressingtheStart "H" key.
Theparameterwillstartashing.
Setthedesiredboilertemperature(rinse)byusingthe"J" (decrease) and "K" (increase)
keys.
ConrmtheselectionbypressingtheStart "H" key.
This parameter sets the rinse water temperature according to the actual needs of both the
objects to be rinsed and the type of rinse-aid chemical in use.
Minimumsettingforrinsetemperature:65°C.
Parameter
Number
Description Standard Version Plus Version
P1
Boiler temperature setting
82 82
P2
Tank temperature setting
55 55
P3
Water hardness* 1-2-3-4 1-2-3-4
P4
Startenablingwithdoor
0 0
P5
Drain pump enabling
0 0
* Visible only if equipped with water softner