Operation Manual

EN
page 29
To exit the programming menu press the "J" key.
1.9.7 Set "5" parameter
By the "K" (decrease) and "L" (increase) key, select the "5" DRAIN PUMP parameter.
ConrmtheselectionbypressingtheStart "H" key.
Theparameterwillstartashing.
Setthedesiredvalue,byusingthethe"K" (decrease) and "L" (increase) keys.
0 - Deactivates the parameter
1-ActivatestheparameterDRAINPUMP
Default value "1".
ConrmtheselectionbypressingtheStart "H" key.
To exit the programming menu press the "J" key.
1.10 Changing the circuit board
In case of substitution of the circuit board, a new start set up has to be made by inserting in the
board the factory bar-code that can be found inside the lower front panel of the machine.
This bar-code allows the habilitation of the circuit board, with factory settings.