Installation Guide

The Basco 100/200 Pivot Shower Door is
completely reversible and may be installed pivot-right
or pivot-left. Using the diagram, determine the correct
position for your installation. For maximum
waterproofing, the pivot jamb should always be
opposite the shower head. These instructions depict a
pivot left installation.
CAUTION: For safety, the door must always open
outward.
Note: The 100/200 unit may be installed without
using the sloped curb [A] provided. Its use is definitely
recommended for positive water control on shower sills
with little or no slope.
Measure the wall-to-wall opening at the shower sill and
cut the curb to the exact length. File the ends of curb as
necessary to fit the corner contours of the enclosure.
Place the curb on the shower sill with the RAISED
portion to the exterior of the enclosure. Make sure the
curb is centered on the sill and lightly mark its position
on the sill with a pencil. Remove the curb from the sill.
Run two beads of caulk inside the penciled marks
on the shower sill. Place the curb [A] in the exact position
marked in Step #2 and seat it firmly in the caulking. Also
caulk the ends of the curb to the walls. Hold curb into
place with masking tape.
NOTE: Improper caulking will result in leaks.
2
3
QCI0001 Rev. 0 Page 4 of 7 Certified 11/10/2006