Installation Guide

10 Place one of the clear bottom guides [V]
in the middle of the tub track as shown. Using
the hole in the back of the bottom guide, drill a
1/8” hole into the inside of the tub track.
Attach the bottom guide with a #6 x 3/8” pan
head screw [W].
OPTION: There are two additional bottom guides
included in the hardware. These can be
installed for additional strength and stability.
Follow the previous instructions to do so.
Exterior
11 Remove the protective backing from the two
squares of tape on the back side of the nylon jamb
covers [X]. Place the jamb covers against the wall jambs
over the notches of the wall jambs at the top, inside of
the header. Press in place.
12 Peel the backing from two of the clear jamb
bumpers [E] and place them against the wall jambs
on the outside of the pockets, one on each wall jamb.
Press them into place approximately in the vertical
center of each wall jamb.
EXTERIOR
NOTE: The placement of these final two clear
jamb bumpers may vary depending on
any out-of-plumb conditions that may
exist. Adjust accordingly.
QCI0017 Rev. 2 Page 7 of 8 Certified 09/08/09