the CLASSIC BYPASS SemiFramless Bypass Tub & Shower Door CLCH05A BECAUSE THE SHOWER IS EVERYTHING www. Bas coSh o w e rD o o r. c o m | 8 0 0 . 4 5 .
Two primary materials are used to manufacture your new enclosure: tempered glass and anodized aluminum. To assure a long lasting finish on the enclosure, wipe it down with a towel after each use. Never use a scouring agent to clean the aluminum. Lysol To install your bath enclosure, you will need the following: Although safety tempered glass is very resistant to breakage, the glass can still break if unequal pressure is placed on it during installation. Use caution.
S. 1 Nylon Bottom Guide T. 2 #6 x 3/8” Pan Head Screws U. 4 Stainless Steel Bumper Inserts J. Y. 3 Anti-Jump Inserts (1 Shown) SC4340-35 Z.
3/16” 3/16” ) QCI5019 Rev 2 Page 4 Certified 12/13/06 Certified 01/10/2020
If not already, slide the anti-jump inserts to the center of the header. NOTE: Header shown and cut away for clarity Measure the wall-to-wall opening at the top of the wall jambs [B] and cut the header [F] 1/16” short of this dimension. Check the header for fit.
7 Slide anti-jumps into position: 1) at left wall jamb 2) at right wall jamb 3) centered in opening Insert 1 SCR11 screw into the pre-drilled hole of each insert. The screws will just press against the header. DO NOT use power tools to insert these screws. DO NOT drill the header for these holes. PRO TIP! If the rollers contact the ant-jump during normal opperation, back the screw out of the insert 1/4 of a turn at a time until less contact is made.
10 QCI5019 Rev 2 Page 7 Certified 01/10/2020
Please Note: Panels will need to be very close to the center of the opening in order to be installed. If there is ever reason to remove the panel, the panel will again need to be centered in the opening.
14 15 QCI-5019 Rev 2 Page 9