Installation Instructions
QCI-5019 Rev 1 Page 8
Anti-jump clips are installed after the panels are hung in
place in the header. Installing the anti -jump clips onto the
panels before hanging on the header can damage the roll-
ers, panels, header, or failure to allow the roller to align
onto the track. These damages are not covered by warran-
ty. Failure of the roller mechanism can lead to personal
injury or damage to the bathroom.
With each panel slightly open, slide the
anti-jump clip onto the hanger bracket as
shown.
Gently push the opening of the anti -jump onto
t
he screw head and roller body until it clicks into
place.
“CLICK
If the Anti -Jump clip does not stay
in place or is dicult to install, snap
o the leg on the roller side. The op-
posite side leg will stay intact.
Portions of the header hidden for clarity. All installation of anti -jumps is done from below.
Illustrations may not match your specic model, but the procedure is the same.
14