Installation Guide

NOTE: Tempered glass cannot be cut.
Although safety tempered glass is very resistant to breakage, the
glass can still break if unequal pressure is placed on it during
installation. Use caution. In addition, the sharp corners of the
panels can damage tile and floor surfaces, so it is best to handle
the glass panels carefully and protect the edges.
MAINTENANCE: Two primary materials are used to manufacture your new shower enclosure:
tempered glass and anodized aluminum. To assure a long lasting finish on the enclosure, wipe it down
with a towel after each use. Never use a scouring agent to clean the aluminum.
For occasional, more concentrated cleaning efforts, we find that Lysol Bathroom Cleaner works
extremely well. Be sure that any over-spray falling on the aluminum frame is rinsed thoroughly and
dried. Many over-the-counter cleaners, if applied ot the aluminum and left on, will harm the metal
finsh and cause permanent damage, even though their directions indicate safe use on shower doors.
INSTALLATION NOTES: Unpack your unit carefully and inspect for freight damage. Layout and
identify all parts using the instruction sheets as a reference. Before discarding the carton, check to see that
no small hardware parts have fallen to the bottom of the box. If any parts are damaged or missing, refer to
the descriptions noted in the instructions when contacting your dealer for replacements.
Handle the glass panels carefully and protect the edges. Safety tempered glass is very resistant to breakage,
but the sharp corners of the panels can damage tile and floor surfaces.
Please wear safety glasses whenever drilling or cutting. When drilling holes in the ceremic tile or marble,
use a center punch and hammer to carefully break the surface glaze so the drill can start without skidding.
To install your new shower door, you will need the following: tape measure, level, #2 Phillips screwdriver,
3/16” wrench, drill, 7/64“, 1/8” and 1/4” drill bits, hacksaw, pencil, and caulking (clear silicone recommended).
Optional tools include a miter box for cutting parts to length, files, center punch, and masking tape.
QCI5022 REV.2
Certified 12/15/16